The pre-trip inspection is on the written test and the skills test, and a lot of people fail the skills test right here. You need to know what to check and what a defect looks like.
These 15 questions cover the engine compartment, cab checks and safety equipment, lights, tires, wheels, suspension, and brakes.
-
Question 1 of 15
What condition should drive belts (such as alternator and fan belts) be in?
Show answerHide answer
Answer: D. Secure, properly tensioned, and free of serious cracks, fraying, or glazing
Belts should be secure, properly tensioned, and free of serious cracks, fraying, glazing, or excessive wear. A failed belt can cause loss of charging (alternator belt), cooling (water pump belt), or steering assist depending on the system.
-
Question 2 of 15
Which exterior lights should a driver confirm are working during a vehicle inspection?
Show answerHide answer
Answer: C. Headlights, clearance lights, turn signals, brake lights, tail lights, and four-way flashers
A driver should check all required exterior lights, including headlights, clearance lights, turn signals, brake lights, tail lights, license plate lights, and four-way flashers. Trailer lights and reflectors must also be checked when pulling a trailer.
-
Question 3 of 15
A previous driver reported a brake defect on the DVIR. There is no signed certification of repair. What should the next driver do?
Show answerHide answer
Answer: D. Confirm the defect was repaired or properly certified as not needing repair before driving
If a previous DVIR shows a safety-related defect, the next driver must verify the defect was repaired or that the carrier certified the repair was not needed before operating the vehicle.
-
Question 4 of 15
What should a driver check about the fire extinguisher during inspection?
Show answerHide answer
Answer: D. That it is present, properly charged, properly rated, and securely mounted
The fire extinguisher should be present, properly charged (check the pressure gauge), rated correctly for the vehicle, and securely mounted so it is available in an emergency and does not become a projectile.
-
Question 5 of 15
A driver finds exposed electrical wiring near the engine. What is the concern?
Show answerHide answer
Answer: A. It can create a short circuit or fire risk
Exposed wiring can short against metal, fail, or ignite a fire if it contacts a hot surface. The driver should report the defect and have it repaired before operating.
-
Question 6 of 15
What is the minimum legal tread depth for steer-axle tires on a CMV?
Show answerHide answer
Answer: C. 4/32 inch
Steer-axle tires must have at least 4/32 inch of tread depth in the major tread grooves. Other tires must have at least 2/32 inch. Tires below the legal minimum must be corrected before operation.
-
Question 7 of 15
What does it mean if a vehicle is placed out of service for a defect?
Show answerHide answer
Answer: A. The vehicle may not be operated until the out-of-service condition is corrected
An out-of-service defect means the vehicle is not allowed to be operated until the condition is corrected and the vehicle is safe and legal to drive.
-
Question 8 of 15
What is the minimum required rating for a fire extinguisher on most CMVs?
Show answerHide answer
Answer: A. A 5 B:C rated fire extinguisher (10 B:C if carrying hazardous materials requiring placards)
Most CMVs require at least a 5 B:C rated fire extinguisher. Vehicles transporting hazardous materials requiring placards must carry a fire extinguisher rated at least 10 B:C. The extinguisher must be properly charged and securely mounted.
-
Question 9 of 15
What is the function of the alternator, and what should be checked during inspection?
Show answerHide answer
Answer: D. It generates electricity to charge the battery; check that it is securely mounted and its belt is in good condition
The alternator generates electricity to charge the battery and power electrical systems while the engine runs. Drivers should check that it is securely mounted and that its drive belt is properly tensioned and free of damage. A failed alternator drains the battery and can cause electrical failure.
-
Question 10 of 15
Why are dual tires inspected to make sure they are not touching each other?
Show answerHide answer
Answer: B. Touching dual tires generate heat and can damage each other, leading to failure
Dual tires should not rub or contact each other during normal operation. Contact creates friction and heat that can cause sidewall damage and tire failure. Underinflation, mismatched tire diameters, poor spacing, or damaged components can cause duals to touch.
-
Question 11 of 15
During a pre-trip inspection, a driver finds a tire with exposed cord. What should the driver do?
Show answerHide answer
Answer: B. Report the defect and not drive until the unsafe condition is corrected
A tire with exposed cord, fabric, or belt material is an out-of-service condition. The driver must not operate the vehicle until the tire is replaced.
-
Question 12 of 15
Why should a driver check dashboard warning lights at startup?
Show answerHide answer
Answer: D. To make sure no warning light stays on that indicates a system problem after the bulb check
Most dashboard warning lights illuminate briefly at startup as a bulb check, then turn off when the system is normal. A warning light that stays on indicates a problem to investigate before driving.
-
Question 13 of 15
A battery is loose in its tray and a cable is rubbing against a sharp metal edge. What is the main risk?
Show answerHide answer
Answer: B. Rubbing can wear through the cable, causing a short circuit, electrical failure, or fire
A loose battery can damage its terminals and cables. A cable rubbing on sharp metal can wear through its insulation, causing a short circuit, electrical failure, or fire. This must be corrected before operating.
-
Question 14 of 15
What can rust trails or shiny metal around lug nuts indicate?
Show answerHide answer
Answer: A. The lug nuts may be loose
Rust trails, shiny metal, or widened lug holes around lug nuts can indicate movement from loose lug nuts. Loose lug nuts can lead to wheel separation, which is a serious safety hazard.
-
Question 15 of 15
During a trip, a driver notices a new air leak sound while stopped. What should the driver do?
Show answerHide answer
Answer: B. Investigate the problem and report it if it is a defect
A new air leak sound may indicate an air brake system problem. The driver should investigate, report the defect, and not continue if the vehicle is unsafe.
Tire and wheel questions are easy points once you know the minimums and what counts as a defect.
Practice saying your pre-trip out loud. On the skills test, you have to explain what you're checking, not just look at it.
Want more questions like these?
CDL Pro has 1,000 practice questions with explanations, timed practice exams, and weak-area drills.