If you're going for a Class A, you need the combination vehicles test. It covers how tractor-trailers handle, how to couple and uncouple, the fifth wheel and kingpin, and the trailer air brakes.

These 15 questions come from all of those. Coupling and trailer brake questions trip a lot of people up, so take your time on those.

  1. Question 1 of 15

    A driver is uncoupling a loaded trailer on soft ground. What should the driver consider?

    Show answerHide answer

    Answer: A. Landing gear may sink into soft ground , use load-bearing planks/dunnage under the landing gear, OR choose a firmer location

    A loaded trailer puts heavy weight on the landing gear. On soft ground, asphalt in heat, mud, or gravel, the landing gear can sink. Use load-bearing planks, pads, or dunnage under the landing gear, or choose a firmer location if needed.

  2. Question 2 of 15

    A driver notices the trailer air lines are crossed at the glad hands (service line connected to emergency line and vice versa). What is the danger?

    Show answerHide answer

    Answer: C. The trailer brakes may not apply correctly when the driver uses the service brake pedal

    If the service and emergency glad hands are crossed, trailer brake operation will not be correct. The service line carries the brake signal from the foot valve, while the emergency/supply line provides air to the trailer system. Crossed lines can leave the trailer without proper service braking or cause air supply problems. Always match blue to service and red to emergency/supply.

  3. Question 3 of 15

    A driver enters a sharp right turn in a tractor-trailer. Which feature is most important to understand for safe negotiation?

    Show answerHide answer

    Answer: D. The trailer wheels may follow a different path than the tractor

    In turns, trailer wheels usually track inside the path of the tractor (off-tracking). The longer the vehicle and tighter the turn, the more pronounced this effect. The driver must allow room for curbs, signs, pedestrians, and nearby vehicles.

  4. Question 4 of 15

    Air lines between the tractor and trailer are stretched tight with no slack. Why is this a problem?

    Show answerHide answer

    Answer: B. Tight lines may pull loose, snap, or be damaged during a turn

    When the tractor turns sharply relative to the trailer, the distance between connection points changes. Lines stretched tight may pull loose, snap, or be damaged. Lines should have enough slack to handle full turns without dragging or rubbing.

  5. Question 5 of 15

    Which trailer air system defect should be corrected before travel?

    Show answerHide answer

    Answer: A. A leaking emergency air line

    A leaking emergency or supply air line can cause trailer air loss and may lead to trailer spring brake application. It can also cause the tractor protection valve to close to protect tractor air. The leak should be corrected before travel.

  6. Question 6 of 15

    What is the purpose of the tug test after coupling?

    Show answerHide answer

    Answer: D. To confirm the fifth wheel is securely locked to the kingpin , driver gently pulls forward with trailer brakes set, verifying no separation

    A tug test confirms the fifth wheel is securely locked to the kingpin. With the trailer brakes locked, the driver gently pulls forward in low gear to make sure the tractor does not separate from the trailer. A tug test should be followed by a visual inspection of the fifth wheel jaws, kingpin, release handle, and apron contact.

  7. Question 7 of 15

    On a sliding fifth wheel, what specific condition must the driver verify before driving?

    Show answerHide answer

    Answer: D. The slider is fully locked in position with all locking pins engaged

    A sliding fifth wheel allows the fifth wheel position to be adjusted forward or rearward for weight distribution. Before driving, the slider must be fully locked with all locking pins engaged. An unlocked slider can shift during driving, dramatically changing axle weight distribution and handling.

  8. Question 8 of 15

    What is rearward amplification?

    Show answerHide answer

    Answer: D. The tendency for movement at the rear trailer to be greater than movement at the tractor during quick steering

    Rearward amplification means steering movements at the tractor are magnified at the rear trailer. A sudden lane change at the tractor can cause much larger lateral movement at the rear of a trailer , increasing rollover and sway risk.

  9. Question 9 of 15

    During a walkaround, the driver finds air lines properly connected, electrical cord connected, trailer doors secured, but the landing gear is still fully down. What should the driver do?

    Show answerHide answer

    Answer: A. Raise and secure the landing gear before driving

    Landing gear must be fully raised and the crank handle secured before driving. Driving with landing gear down can damage the equipment and cause the legs to strike the road, curbs, railroad crossings, or other obstacles.

  10. Question 10 of 15

    What does the emergency air line do?

    Show answerHide answer

    Answer: C. Supplies air to the trailer air tanks and triggers trailer emergency brakes if pressure is lost

    The emergency or supply air line, usually connected with the red glad hand, supplies air to the trailer air tanks during normal driving. If this line is cut, disconnected, or loses pressure, the trailer emergency or spring brakes should apply.

  11. Question 11 of 15

    Why must trailer brakes be applied before uncoupling?

    Show answerHide answer

    Answer: D. To keep the trailer from rolling away once it's no longer connected to the tractor's brakes

    Trailer brakes must be applied before uncoupling so the trailer cannot roll once it is separated from the tractor. Pulling the trailer air supply control shuts off supply air and applies the trailer emergency/spring brakes on modern trailers. Chock wheels when required, especially if the trailer does not have spring brakes or you are unsure.

  12. Question 12 of 15

    A driver notices the fifth wheel skid plate is dry with little or no lubrication. What problem can this cause?

    Show answerHide answer

    Answer: B. Hard steering, uneven trailer tracking, accelerated wear, and possible plate damage

    A dry fifth wheel creates excess friction between the trailer apron and the fifth wheel plate. This can cause hard steering, uneven trailer movement, accelerated wear, and possible damage. The plate should be properly lubricated before operation.

  13. Question 13 of 15

    Which driving habit best helps keep a combination vehicle stable?

    Show answerHide answer

    Answer: B. Keeping steering, braking, and acceleration smooth

    Smooth steering, braking, and acceleration help keep the trailer stable. Sudden inputs can cause sway, skid, jackknife, or rollover , especially in loaded combination vehicles.

  14. Question 14 of 15

    Which fifth wheel mounting condition should stop the driver from operating?

    Show answerHide answer

    Answer: C. The fifth wheel mounting plate is cracked or has missing bolts

    A cracked fifth wheel mounting plate or missing mounting bolts can lead to fifth wheel failure and trailer separation while driving. The driver should not operate the vehicle until the fifth wheel mounting defect is repaired.

  15. Question 15 of 15

    A trailer breaks away from the tractor and the emergency air line separates. What should happen automatically?

    Show answerHide answer

    Answer: D. The trailer emergency/spring brakes should apply, and the tractor protection valve should close to preserve tractor air

    Breakaway protection is designed to work in two ways: loss of emergency line pressure causes the trailer emergency or spring brakes to apply, and the tractor protection valve closes to keep tractor air from being lost through the trailer line. This helps the tractor retain air for braking while the trailer brakes apply.

0 / 15Answer the questions above to see your score

Missed coupling questions? Go through the steps in order until you can say them without thinking. They come up on the written test and the skills test.

Trailer air brake questions get a lot easier once you know what the tractor protection valve and the trailer supply valve actually do.

Want more questions like these?

CDL Pro has 1,000 practice questions with explanations, timed practice exams, and weak-area drills.

← Back to blog